2020 ABS-Body Electromagnetic Flowmeter

The 2020 ABS-Body Electromagnetic Flowmeter, coupled with the I500 or M500 flow transmitters are ideally suited to accurately measure the flow rate of a wide variety of conductive process liquids including water, wastewater, effluent and selected chemical applications.

The 2020 ABS-Body Electromagnetic Flowmeters can be paired with either Solar or 240VAC electronics, including the I500 and M500.

The 2020 ABS-Body Electromagnetic Flowmeters are compatible with legacy I300 and M300 Flowmeters.



  • Uses the well proven electromagnetic method of measurement.
  • Typical flow accuracy better than ±0.5% of indicated flow rate.
  • No moving parts
  • Wide operating range
  • No obstruction to the flow
  • Negligible pressure loss
  • Spool or stub-flange construction types available
  • Robust construction
  • Submersible to 1.5 metres of water.
  • Suitable for buried service
  • Minimal straight pipe installation requirements
  • Remotely mounted electronics



  • Pipe-Not-Full detection
  • Electrical Conductivity checking
  • Available with standard and aggressive service electrodes
  • Long term reliability

Accuracy: Refer to chosen transmitter user manual (I500, M500, I300, M300).

Velocity Range: 0.01 to 10.0 metres per second.

Pressure Effects: Negligible

Power supply variations: negligible effect on meter accuracy provided the supply voltage is within the rated range for the electronics

Metering tube material: ABS

Sizes: 50,80,100,150,200,250,300,375,450mm.

Earthing: Earthing electrodes

Process Flange: Slip ring galvanized rings, optional stainless steel.

Pressure limits: limited by meter size. Pressures shown are rated at 20°C only.

50mm = 1500kPa
80mm = 1200kPa
100-200mm = 1200kPa
250mm = 1200kPa
300mm+ = 900kPa

Note:     Detailed site installation and wiring instructions are located within the I500                    Electromagnetic Flowmeter and M500 Electromagnetic Flowmeter installation and operations manuals.

Enquire about this product

  • This field is for validation purposes and should be left unchanged.